If the operation is completed, the small concrete mixer will be idle in the warehouse. At this time, many people will feel that there will be no problem if it is idle. However, it is not. Rust and deformation should be prevented when the small concrete mixer is idle!
After the operation of the small concrete mixer truck, it is necessary to remove the external dirt, clean the feed and debris in the working mechanism, and clean with water or oil when necessary. All lubricating parts must be cleaned and re-lubricated. After cleaning the mixer, the operator should also apply oil or stickers on the mixer to reduce the chance of oxidation of equipment in contact with air. I suggest placing the mixer in a cool, dry and ventilated room.
Complex and precise equipment should be placed indoors in a cool, dry and ventilated place. Simple equipment can be stored in the open air, but should be placed in a high, dry place without direct sunlight. It can cover a shed and all parts in direct contact with the ground. Support with wood or brick, and brush the fallen protective paint again.
Spring of small concrete mixer. Drive belt. Long handle. Due to long-term stress or unreasonable placement, plastic deformation of parts will occur, so appropriate support points should be added under the mixer frame to reduce the load of the mixer. In addition, the removed spare parts such as tires and seeding pipes should be properly kept to prevent extrusion deformation.
For small concrete mixer trucks parked for a long time, a registration card shall be established to record the technical conditions, accessories, spare parts and tools of the machines and tools in detail. If there is no warehouse, when the machine is parked outdoors, take out the motor, drive belt and other parts that are easily lost, mark and store them indoors.
If it is used again, it is necessary to make preparations before starting up, such as checking whether the transmission clutch and brake are flexible and reliable, whether the wire rope is damaged, whether the track wheel is in good condition, whether there are obstacles around and the lubrication of all parts.
After starting, always pay attention to whether all parts of the mixer operate normally. Always check whether the blades of the mixer are bent and whether the screws are knocked off or loose when the machine is stopped. Come to our website for more information about the use of mixer trucks Ask about it!